Skip to main content

Fairy Park in Anakie, Victoria

For General Enquiries & Bookings
Call: (03) 5284 1262 or email: info@fairypark.com

Address
2388 Ballan Road
Anakie 3221
Victoria, Australia.   


Admission between 10 am to 4 pm.
Gates close at 5pm sharp.

Open Daily*
All year round. Rain, hail or shine.
We do not close for the winter.
Open all public holidays*

*except Christmas Day


View Travel in a larger map
Direction:

Fairy Park is approximately one hours drive west of Melbourne.
Take the West Gate Bridge out of Melbourne following the Princess Freeway. Take the first Werribee exit marked C109 and follow this road through to the Werribee Racecourse. Along the Racecourse runs Bulban Rd. Spelt B-U-L-B-A-N. Follow Bulban Road to the end and follow the Fairy Park signposts at each intersection. 
Labels:
Location: Victoria, Australia

Comments

Post a Comment

Popular posts from this blog

Box Hill High School Zone

Parents are struggling with moving into a good reputable school for their kid(s). Here is the zone for Box Hill High School.   Good luck with house hunting!
Post a Comment
»»»»»»»»»»»»»»»»»»» Read more »»»»»»»»»»»»»»»»»»»

The Bose Soundbar 700 Won't Connect to App

Bose has one of the best speaker sound. I learnt about Bose more than 25 years ago and still a fan.  I bought Soundbar 700 in 2018.  It took me a while to set it up but it has been giving me troubles once a while.  Recently, I was not able to connect Soundbar 700 with my phone.  Done the factory reset on the soundbar, it didn't work. I spent hours reseting everything multiple times and finally I found this article,  https://www.bose.com.au/en_au/support/articles/HC1380/productCodes/bose_soundbar_700/article.html .  Tweaking them all and finally got it to work again. I think the most important setting is to TURN WPS OFF on the router!  Hope it helps.
Post a Comment
»»»»»»»»»»»»»»»»»»» Read more »»»»»»»»»»»»»»»»»»»

Brivis Heater - Error Code #69

My Brivis HX23 Heater broke down this week.  H01 Code #69.  This code was not even listed in the User Manual!  Searching around the web and here is what I found: Secret Reset: This is not in the User Manual.  On the networker controller press FUNCTION > 1 > 4 keys and the screen will go blank and come back on after 30 seconds, this has rebooted the main PCB and reset the fault code. Use this with caution as too much gas build up could cause an explosion. Use it only after the unit has enough time to air out the gas build up. What is Code #69 or any other unpublished codes?  The best way to find out is to open up the heater unit.   There is a little LCD on the PCB showing what error exactly is. (Note: Opening up the unit may void your warranty.)
6 comments
»»»»»»»»»»»»»»»»»»» Read more »»»»»»»»»»»»»»»»»»»